SimpleTech ZeusIOPS Manual Pagina 26
- Pagina / 110
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
24 Zeus
IOPS
3.5-Inch Fibre Channel Solid State Drive
ELECTRICAL SPECIFICATIONS
POWER SUPPLY
The following voltage specification applies to the drive power connector. Connections to the drive
should be made in a safety extra low voltage (SELV) circuit.
Adequate secondary over-current protection must be incorporated in the host system (drive
enclosure, backplane, etc.). A 10 amp limit is required for safety purposes.
POWER REQUIREMENTS
The SSD requires a 12V +/-10% DC power source. If a power failure occurs, the drive design ensures
that the data contained in the storage memory is preserved. Data loss or corruption does not occur.
Table 4. SSD Power Requirements
POWER CONSUMPTION
Table 5. SSD Typical Power Consumption
The drive does not use the +5V supply input
pins available on a typical 40-Pin SCA-2
connector. The drive uses the +12V supply
input. The 5V ground pins are connected to
the common ground plane within the unit.
To avoid damage to the drive, power supply
voltage transients must not exceed 16 volts.
Item Requirement
Input Voltage 12V +/-10%
Minimum Voltage 10.8
Maximum Voltage 13.2
Activity Average Current (mA) Average Power (W)
Startup 1,200 14.4
Idle 450 5.4
Max Read @ 200MB/sec 700 8.4
Max Write @ 100MB/sec 675 8.1
Read, 1 Block Random I/O @ > 50,000 525 6.3
Write, 1 Block Random I/O @ > 18,000 660 7.9
- Fibre Channel 1
- 3.5-Inch Solid State Drive 1
- Product Manual 1
- Trademark Information 2
- Disclaimer of Liability 2
- Copyright Notice 2
- CONVENTIONS 3
- REVISION HISTORY 5
- TABLE OF CONTENTS 7
- LIST OF TABLES 13
- LIST OF FIGURES 17
- OVERVIEW 19
- AUDIENCE 19
- REFERENCE DOCUMENTS 20
- PRODUCT DESCRIPTION 21
- PERFORMANCE CHARACTERISTICS 22
- MOUNT TIME 23
- ACCESS TIME 23
- DATA TRANSFER RATES 23
- ERASE TIMES 24
- SANITIZE 24
- HOT PLUGGING 25
- PREVENTATIVE MAINTENANCE 25
- ELECTRICAL SPECIFICATIONS 26
- GROUNDING 27
- FAULT LED OUT SIGNAL 27
- READY LED OUT SIGNAL 27
- SEL_ID FUNCTION 28
- P_ESI_n FUNCTION 29
- START_n MATED 30
- -DRIVE PRESENT 30
- DEV_CTRL_CODE_X 30
- INTERFACE SPECIFICATIONS 31
- SCA-2 INTERFACE CONNECTOR 32
- CONNECTOR LOCATION 32
- CONNECTOR PINOUT 33
- VOLTAGE AND GROUND SIGNALS 33
- FC-AL FEATURES 34
- FCP-SCSI COMMANDS 35
- EPORT LUNS (A0h) 37
- EST UNIT READY COMMAND (00h) 38
- ORMAT UNIT (04h) 38
- EASSIGN BLOCKS (07h) 39
- EAD (6) COMMAND (08h) 40
- RITE (6) COMMAND (0Ah) 40
- NQUIRY COMMAND (12h) 41
- ODE (6) SELECT (15h) 43
- ODE (6) SENSE COMMAND (1Ah) 44
- TART/STOP UNIT (1Bh) 45
- END DIAGNOSTIC (1Dh) 48
- EAD CAPACITY (25h) 48
- Table 29. Read Capacity CDB 49
- READ (10) EXTENDED (28h) 50
- RITE EXTENDED (10) (2Ah) 51
- RITE AND VERIFY (10) (2Eh) 51
- ERIFY (10) (2Fh) 51
- RITE BUFFER COMMAND (3Bh) 52
- EAD BUFFER (3Ch) 53
- EAD (10) LONG (3Eh) 54
- RITE (10) LONG (3Fh) 54
- YNCHRONIZE CACHE (10) (35h) 55
- EAD (10) DEFECT DATA (37h) 55
- RITE (10) SAME (41h) COMMAND 56
- OG SELECT COMMAND (4Ch) 56
- OG SENSE COMMAND (4Dh) 57
- ODE (10) SELECT (55h) COMMAND 58
- ODE SENSE (10) COMMAND (5Ah) 59
- UNSUPPORTED COMMANDS 61
- SMART SPECIFICATION 62
- DIAGNOSTICS 63
- SCSI IMPLEMENTATION 63
- EVENTS CURRENT VALUES 64
- LOG SENSE 65
- LOG SELECT 66
- SUPPORTED LOG PAGES 67
- LOG PAGE 2H - WRITE ERRORS 68
- LOG PAGE 3H - READ ERRORS 69
- VENT NOTIFICATION VIA SCSI 72
- Byte76543210 74
- Table 46 76
- FIBRE CHANNEL STANDARD 77
- FABRIC NODE CONNECTION 79
- Table 47. FCP Function Levels 81
- PHYSICAL CHARACTERISTICS 82
- EXTERIOR DIMENSIONS 83
- ENVIRONMENTAL CHARACTERISTICS 84
- AXIMUM COMPONENT TEMPERATURES 85
- ELATIVE HUMIDITY 86
- LTITUDE PARAMETERS 86
- HOCK AND VIBRATION 86
- AILURE CRITERIA 86
- OPERATING SHOCK AND VIBRATION 87
- DROP TESTING 87
- INSTALLATION 88
- DRIVE CONFIGURATION 89
- FAULT SIGNALS 89
- OWER-ON FAULT CONDITIONS 90
- PERATIONAL FAULT CODES 91
- DRIVE ORIENTATION 93
- PRIMARY HEAT GENERATION AREA 94
- COOLING REQUIREMENTS 95
- MOUNTING DIMENSIONS 96
- DRIVE INSTALLATION 97
- GROUNDING REQUIREMENTS 97
- MICROSOFT OS COMPATIBILITY 98
- SSD MANAGEMENT UTILITY 99
- DIAGNOSTIC SOFTWARE 99
- REGULATORY COMPLIANCE 100
- RADIO FREQUENCY EMISSIONS 101
- EMI TEST SITE CORRELATION 101
- VERIFICATION SAMPLES 101
- VERIFICATION TESTING 101
- ELECTROSTATIC DISCHARGE (ESD) 102
- Contact Information 103
- Ordering Information 103
- 102 Zeus 104
- 104 Zeus 106
- Regulatory Compliance 107
- SCSI Commands 107
- SMART Specification 107
- Unsupported SCSI Commands 108
- Warranty 108
- CERTIFICATION AND WARRANTY 109
- 61000-04522-101: Revision 1.6 110
Relacionado con productos y manuales para Redes SimpleTech ZeusIOPS
Redes SimpleTech STI-FAX/33.6 Guía de usuario
(0 paginas)
(0 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.091 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales