SimpleTech ZeusIOPS Manual descargar pdf (Pagina 92)

90 Zeus

IOPS

3.5-Inch Fibre Channel Solid State Drive

SINGLE CHANNEL MODE FOR EARLY REVISION DRIVES

On early revisions of the drive, JP1 did not exist. These drives are identified by having a serial number

of “50” or less and only have an 8-way right-angled manufacturing connector. For this revision of

drive, the feature is enabled by setting bit 6 of the LOOP_ID to “1”. The LOOP_ID is set using the

SELECT_ID pins on the SCA-2 connector within the chassis to which the SSD is connected. See the

SEL_ID Function.

The SELECT_ID bits are normally configured by jumpers or a switch that allows the ID of the drive

to be set using the backplane of the SCA-2 connector. Table 57 lists the various configurations of the

SELECT_ID function.

Table 57. SELECT_ID Configurations

Bit 6 Bits 5 -1 Bit 0 Configuration Result

0 XXXXX X Loop ID 0 - 63

Drive operates down both channels.

1 XXXXX 0 Loop ID 64 - 126 and even

Drive operates down channel A only.

1 XXXXX 1 Loop ID 65 - 127 and odd

Drive operates down channel B only.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 109 110

Sin comentarios

SimpleTech ZeusIOPS Manual Pagina 92